Filter
Top Products
Getting Started Getting Started
2
ENGLISH
ENGLISH
Accessories
Check that the following parts are attached in addition to the main
unit:
q Operating instructions .............................................................1
w Service station list....................................................................1
e Pin-plug cable (Cable length: Approx. 0.6 m)...........................1
r System cable (Cable length: Approx. 0.5 m)...........................1
r
e
Before using
Pay attention to the following before using this unit:
• Moving the unit.
To prevent short-circuits or damaged wires in the connection cables,
always unplug the power supply cord and disconnect the connection
cables between all other audio components when moving the unit.
•
Cautions on using mobile phones.
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
• Condensation (dew).
Water droplets may condense on internal operation parts if the set
is brought into a heated room from the cold outdoors or when the
room is heated rapidly. If this happens, the set may not operate
properly.
• Should condensation occur.
The condensation will evaporate in one hour or less, at which time
the system will function normally.
•Before turning the power operation switch on.
Check once again that all connections are correct and that there are
not problems with the connection cables. Always set the power
operation switch to the standby position before connecting and
disconnecting connection cables.
• Store these instructions in a safe place.
After reading, store this instructions along with the warranty card in
a safe place.
•Power is supplied to some of the circuitry even when the power
is set to the standby mode using the power operation switch.
When traveling or leaving home for long periods of time, be
sure to unplug the power supply cord from the power outlet.
• Note that the illustrations in these instructions may differ from
the actual unit for explanation purposes.
About discs
NOTE:
• This CD player uses a semiconductor laser. To ensure stable
operation, it is recommended to use the set indoors at a
temperature of 5°C (41°F) ~ 35°C (95°F).
Discs usable on this set
q
Music CDs
Discs with the mark at the right can be used on
this set.
Note however that discs with special shapes
(heart-shaped discs, octagonal discs, etc.) cannot
be played. Do not attempt to play them, as doing
so could damage the set.
w
CD-R/CD-RW
•Some discs and some recording formats may not be playable.
•Non-finalized discs cannot be played.
Finalization:
Finalization is the process that makes recorded CD-R/CD-RW discs
playable on compatible players.
Holding discs
Do not touch the signal surface.
Loading discs
•Set the disc with the labeled side facing up.
•Make sure the disc tray is fully open when inserting the disc.
•Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1),
8 cm discs in the inner tray guide (Figure 2).
Figure 1
Outer tray guide
12 cm discs
Figure 2
Inner tray guide
8 cm discs
• Place 8 cm discs in the inner tray guide without using an adapter.
• In the following cases, “00 m 00 s” is shown on the display:
• When no disc is loaded
•When the disc is loaded upside-down
•When the disc’s information could not be read properly