Denon DCD-F102 CD Player User Manual


 
Others
16
ENGLISH
ENGLISH
¢ Audio performance
No. channels: 2 channels
Frequency response: 2 Hz ~ 20 kHz
Dynamic range: 100 dB
S/N: 105 dB
Harmonic distortion: 0.005 % (1 kHz)
Separation: 95 dB
Wow & flutter: Below measurable limits (± 0.001 % W. peak)
Analog audio output: Output level : 2.0 Vrms (LINE OUT)
¢ Usable discs: Compact Disc
Diameter: 120 mm/80mm
¢ Signal format
Sampling frequency: 44.1 kHz
Quantization bit: 16-bit linear/channel
Transfer bit rate: 4.3218 Mb/seconds
¢ Digital output signal format
Format: Digital audio interface
Optical output: –15 ~ –21 dBm
Emission wavelength: 660 nm
¢ Pickup
Type: Objective lens drive type pickup
Objective lens drive type: Secondary parallel drive
Light source: Semiconductor laser
Wavelength: 780 nm
¢ General
Power supply: AC 230 V, 50 Hz
Power consumption: 15 W
Standby : 0.1 W or less
Maximum external dimensions: 250 (W) x 78 (H) x 250 (D) mm (Not including protruding parts)
250 (W) x 82 (H) x 260 (D) mm (Including protruding parts)
Mass: 2.9 kg
* For purposes of improvement, specifications and design are subject to change without notice.
Specifications
If a problem should arise, first check the following:
1. Are the connections correct ?
2. Have you operated the player according to the Operating Instructions ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction. Disconnect the power immediately and contact your store of purchase.
PageMeasuresCauseSymptom
Display does not light and
no sound is produced
when power is turned on.
Power supply cord is not plugged
into power outlet.
•Plug the power supply cord into the
power outlet.
6
“00 m 00 s” is shown on
the display even though a
CD is loaded.
•The disc is not properly loaded. • Reload the disc. 2
Disc is not played when
1/3 button is pressed.
The disc is dirty or scratched. • Wipe the dirt off the disc or replace
the disc.
6
No sound is produced or
sound is distorted.
Incomplete connections with the
various devices.
The receiver’s function setting or
adjustments are not right.
Check the connections.
Check the receiver’s function and
controls and adjust as necessary.
Specific section of the
disc cannot be played
properly.
The disc is dirty or scratched. • Wipe the dirt off the disc or replace
the disc.
3
Programmed playback is
not possible.
The tracks have not been
programmed properly.
•You are playing a disc containing files
in MP3 or WMA format.
•Program properly.
•Programmed playback is not
possible with containing files in MP3
or WMA format.
8
A CD-R or CD-RW disc
cannot be played.
The disc has not been finalized.
The recording conditions are bad or
the quality of the disc itself it poor.
Finalize the disc then play it.
Use a properly recorded disc.
2
“Not Support” is
displayed when playing
riles recorded in MP3 or
WMA format.
•You have selected a copyright-
protected WMA file or a file that
cannot be played normally.
Use the 8/6 or 7/9
button on the main unit (the 8 or
9 button on the remote control
unit) to select a different file.
11, 12
3
Troubleshooting
Others