Filter
Top Products
Setting the Auto Surround Mode
For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory. At next time it the same signal
inputs, the memorized surround mode is automatically selected and the signal is played.
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL Default Auto Surround Mode
q Analog and PCM 2-channel signals STEREO
w 2-channel signals of Dolby Digital, DTS or other multichannel format Dolby PL
IIx Cinema
e Multichannel signals of Dolby Digital, DTS or other multichannel format Dolby or DTS Surround
1
Press the ENTER or (down) button to switch the Ext. In SW Level setting.
Setting the Ext. In SW Level
Set the playback level of the analog input signal connected to the Ext. In terminal.
1
Press the ENTER or (down) button to switch the Power Amp Assignment setting.
Select “ON” if you want to use the auto surround mode, “OFF” if
you do not want to use it.
2
24 AUTOSURR. ON
25 EXT.IN SW+15
Select desired setting.
• Select according to the specifications of the player being used.
Also refer to the player’s operating instructions.
• +15dB (default) recommended. (0, +5, 10 and +15 can be
selected.)
2
28
ENGLISH