12 RMX465D
Radio Operations
FM reception
For enhanced FM performance the
®
tuner includes signal actuated
stereo control and Multipath noise reduction
circuits.
Changing the reception area
This unit is initially set to USA frequency intervals
of 10kHz for AM and 200kHz for FM. When using it
outside the USA, the frequency reception range
can be switched to the intervals below.
● Setting the reception area
1. Press BND button @ and select the desired
radio band (FM or AM).
2. While pressing BND button @, each time you
press and hold the SRCH left button # for 2
second or longer, the reception area switches
from inside the U.S.A. Also, while pressing
BND button @, press and hold the SRCH right
button # for 2 second or longer, the reception
area switches from outside U.S.A.
∗ Any station preset memories are lost when the
reception area is changed.
Listening to the radio
1. Press FNC button 3 and select the radio
mode.
2. Press BND button @ and select the radio
band. Each time the button is pressed, the
radio reception band changes in the following
order:
FM1 ➜ FM2 ➜ FM3 ➜ AM ➜ FM1...
3. Press the right or left side of SRCH Left or
Right button # to tune in the desired station.
Tuning
There are 3 types of tuning mode available, seek
tuning, manual tuning and preset tuning.
Seek tuning
1. Press BND button @ and select the desired
band (FM or AM).
∗ If “MANU” is lit in the display, press and hold
BND button @ for 1 second or longer. “MANU”
in the display goes off and seek tuning is now
available.
2. Press the right or left side of SRCH Left or
Right button # to automatically seek a station.
When the SRCH Left or Right button # is
pressed, the station is sought in the direction
of higher frequencies; if the left side of SRCH
button # is pressed, the station is sought in
the direction of lower frequencies.
Manual tuning
There are 2 ways available: Quick tuning and step
tuning.
When you are in the step tuning mode, the
frequency changes one step at a time. In quick
tuning mode, you can quickly tune the desired
frequency.
1. Press BND button @ and select the desired
band (FM or AM).
∗ If “MANU” is not lit in the display, press and
hold BND button @ for 1 second or longer.
“MANU” lights in the display and manual tuning
is now available.
2. Tune into a station.
● Quick tuning:
Press and hold the right or left side of SRCH
button # for 1 second or longer to tune in a
station.
● Step tuning:
Press the right or left side of SRCH button #
to manually tune in a station.
Recalling a preset station
A total of 24 preset positions (6-FM1, 6-FM2, 6-
FM3, 6-AM) exists to store individual radio
stations in memory. Pressing the corresponding
preset button recalls the stored radio frequency
automatically.
1. Press BND button @ and select the desired
band (FM or AM).
2. Press the corresponding Preset button 0 to
recall the stored station.
∗ Press and hold one of the Preset buttons 0
for 2 seconds or longer to store that station into
preset memory.
Manual memory
1. Select the desired station with seek tuning,
manual tuning or preset tuning.
2. Press and hold one of Preset buttons 0 for 2
seconds or longer to store the current station
into preset memory.