Filter
Top Products
E-38
Setting up the Bridge Basic Cradle
Connecting without Using the AC Adaptor
• It is possible to draw power from the personal computer in the bus power mode. This
makes it possible to operate the Bridge Basic Cradle without using the AC adaptor.
• Power is not supplied to the DT-930 when the USB connection is used to supply power.
Replace the batteries to transfer data if the low voltage message is displayed on the DT-
930. Also, use a personal computer that has USB connectivity that supports high-power
devices.
• Some personal computers cannot provide a stable power supply, confirm whether your
computer can provide a stable power supply. If it is unstable use the optional AC adaptor.
Important! • Mount the DT-930 firmly and make sure that the LED power indicator
on the front of the Bridge Basic Cradle lights green. If it is not correctly
mounted communication cannot be done.
• Do not allow the supply contacts in the Bridge Basic Cradle to short
circuit. If they short circuit it may cause a malfunction.
• Do not shake or hit the Bridge Basic Cradle or DT-930 during
communications over the USB interface. Doing so may interrupt
communications.
• The infrared communication function uses a high-sensitivity
communication element.
To ensure proper communication, avoid using devices that generate
radio waves (for example; cell phones, etc.) in the vicinity of the DT-930
while communication is in progress.
Move these devices away from the DT-930 to use them (cell phones
should be moved more than 30 cm away).
• The cradle does not have the capability of charging battery pack
installed in DT-930.
• The cradle (HA-E60IO) is not operable with DT-900.