Filter
Top Products
Parameter 7 - “Setup RS-232 Slave Control” enables you
to set up communication between multiple connected
B&K products.
The Transmit ID is normally set to ALL. If ALL is select-
ed, control of any connected B&K products will then be
possible. However, if you select the ID# of a specific
B&K product, only that unit will be controlled. This is
useful if several B&K products are interconnected for
other purposes.
There are two options that can be selected.
YES (Default) - Enables all RS-232 commands to be
transmitted out the zones port.
NO - Only disables only auto BKC-DIP commands from
being transmitted out the zones port.
Note: RS-232 macro strings and Keypad feedback infor-
mation will still be transmitted out the zones port.
Memory Backup
When Memory Backup/Restore is highlighted, press the
SEL/ENTER key to backup all system settings to the
EEPROM.
To Retore all system settings, use the Left/Right keys to
change the option to RESTORE. Press the SEL/ENTER
key to restore all settings that were previously backed up
on the EEPROM.
If the system has never been backed up, selecting
RESTORE will restore the unit to factory default.
Refer to page 23 for CT602/CT300 reset procedure.
Control System Setup
BK&
SBIMPLY ETTER!
77
SETUP RRS-2232 SSLAVE CCONTROL
2 TTransmit IID ALL
3 EEnable PPort AA Yes
4 EEnable PPort BB Yes
5 EEnable PPort CC Yes
6 EEnable PPort DD Yes
7 EEnable PPort EE Yes
8 EEnable PPort DD Yes
↑↑↓↓ nneexxtt iitteemm aaddjjuusstt ←←→→
MMEENNUU sseettuupp ccoonnttrrooll
1 EEnable SSlave CControl Yes
SETUP RRS-2232 SSLAVE CCONTROL
1 EEnable SSlave CControl Yes
2 TTransmit IID ALL
3 EEnable PPort AA Yes
5 EEnable PPort CC Yes
6 EEnable PPort DD Yes
7 EEnable PPort EE Yes
8 EEnable PPort DD Yes
↑↑↓↓ nneexxtt iitteemm aaddjjuusstt ←←→→
MMEENNUU sseettuupp ccoonnttrrooll
4 EEnable PPort BB No
MEMORY BBACKUP/RESTORE
save aall ssetting tto
EEPROM MMemory
SSEELL ddoo iitt aaddjjuusstt ←←→→
MMEENNUU mmaaiinn mmeennuu
1 MMemory OOperation BBackup