Filter
Top Products
30
Set the low pass filters slope -
From Remote From Front Panel Action
1
À(UP) or §(DOWN)
(UP) or (DOWN) move to Low Pass
2
¶(LEFT) or •(RIGHT)
VOLUME KNOB adjust filter slope to desired value
Set your LFE (.1) channel level - Usually this will be set to 0.0 dB (default). However, if you have no subwoofer
you may wish to reduce the low frequency effects (LFE) channel to lessen its contribution to the bass going to
your remaining large speakers. Or, even with a subwoofer, you may just wish to reduce the overall LFE level,
especially in an apartment situation. Note that this affects only the separate LFE (.1) channel available on Dolby
Digital and DTS material it has no effect on the reproduction of normal bass from the front, center, or surround
channels.
From Remote From Front Panel Action
1
À(UP) or §(DOWN)
(UP) or (DOWN) move to LFE Level
2
¶(LEFT) or •(RIGHT)
VOLUME KNOB adjust level to desired value
SETUP CROSSOVERS + LFE
1 Crossover 80.0 Hz THX
2 High Pass 12.0 dB THX
3 Low Pass 24.0 dB THX
4 LFE Level -20.0 dB
next item adjust
MENU speaker setup
3 Low Pass 24.0 dB THX
LO PASS 24.0 DB
SETUP CROSSOVERS + LFE
1 Crossover 80.0 Hz THX
2 High Pass 12.0 dB THX
3 Low Pass 24.0 dB THX
4 LFE Level -20.0 dB
next item adjust
MENU speaker setup
4 LFE Level -20.0 dB
LFE LVL -20.0 DB