Filter
Top Products
Z2 Setup
Z2 Level Control - You may wish to install an in-wall volume control in your second zone. This can cause
confusion between your receiver’s internal zone 2 volume controls and your in-wall controls.
WARNING - Setting Z2 LEVEL CONTROL to FIXED will cause your receiver to immediately send its
maximum zone 2 volume to your second zone (if zone 2 is on). Turn down your in-wall volume controls
before making this change.
ADVANCED SYSTEM SETUP
1 Zone 1 Setup
2 Zone 2 Setup
move to new line
previous page
↑ ↓
MENU
select menu pageSEL
3 Power On Titles
4 Control Out
5 Security Options
2 Z2 Fixed Level +15 dB
3 Z2 Product ID 2
move to new line
previous pa
g
e
↑ ↓
MENU
4 V2 Output Tape
1 Z2 Level Control Fixed
adjust parameter
←→
WARNING Connectin
g
a tape
recorder to V2 in LINE mode
can cause speaker dama
g
e
ADVANCED ZONE 2 SETTINGS
select Zone 2 Fixed or VariableVOLUME KNOB
(REW) or
(FF)
4
move to Z2 Level Control
∧
(UP) or
∨
(DOWN)
(PAUSE) or
(STOP)
3
activate ADVANCED ZONE 2 SETTINGS
↵
(ENTER)
SEL or ENTER2
move to Zone 2 Setup
∧
(UP) or
∨
(DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
Z2 Max (Fixed or Variable) Level -
Z2 max level allows you to set a maximum volume level for zone 2. This is
very useful if you are using speakers that can’t handle the maximum power output from your external amplifier or if
you simply wish to limit the volume that can be achieved using normal front panel or remote operation. If you have
chosen zone 2 level control (fixed), then this setting becomes the fixed level for zone 2. If you have chosen zone 2
level control (variable) then this setting allows the level for zone 2 to be adjusted. However, when adjusting this
level it cannot exceed the value set in Z2 max level.
WARNING - If you set this level too low, the receiver may appear broken (no sound).
or
2 Z2 Max Level +15 dB
3 Z2 Product ID 2
move to new line
previous pa
g
e
↑ ↓
MENU
4 V2 Output Tape
1 Z2 Level Control Variable
adjust parameter
←→
WARNING Connectin
g
a tape
recorder to V2 in LINE mode
can cause speaker dama
g
e
ADVANCED ZONE 2 SETTINGS
2 Z2 Fixed Level +15 dB
3 Z2 Product ID 2
move to new line
previous pa
g
e
↑ ↓
MENU
4 V2 Output Tape
1 Z2 Level Control Fixed
adjust parameter
←→
WARNING Connectin
g
a tape
recorder to V2 in LINE mode
can cause speaker dama
g
e
ADVANCED ZONE 2 SETTINGS
set to desired levelVOLUME KNOB
(REW) or
(FF)
2
move to Z2 Max or Fixed Level
∧
(UP) or
∨
(DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
44
p/n 12699 Rev. 9812C