Filter
Top Products
Set Stereo Operation - Most users wll prefer the factory setting - NORMAL. In this mode, the settings you will
enter in the following speaker setup apply to the STEREO surround mode as well as all the other modes. Users
with large front speakers may wish to use them with a subwoofer for movies to keep the extreme bass contained
in some movies out of their front speakers. However, they may wish to use their front speakers as full range
speakers when listening to stereo music material. If this is your case then set STEREO OPERATION to LARGE.
We do not recommend using the LARGE setting if you use small, satellite or bookshelf speakers as the bass
information even in stereo music may damage the speakers at high volume levels. Some users may prefer the
sound of their source’s (or separate) digital to analog converter over the converter contained in the receiver but
still wish to use the receiver’s converter for Dolby Digital and DTS material. If this is your case then set STEREO
OPERATION to DIRECT. Make sure you have made both analog and digital connections from your source. In this
mode when you choose STEREO your receiver will ignore the digital inputs. Note that direct mode also bypasses
bass management so that you get the purest possible sound from your outboard equipment. This means that, like
LARGE mode, you should not use DIRECT mode with small, satellite or bookshelf speakers.
SURROUND MODE OPERATION
Dolby Digital / DTS 5.1
adjust parameter
previous page
←→
MENU
1 Surround Operation Auto
overrides MODE setting
2 Stereo Operation Normal
STEREO MODE is Digital
Front L/R speaker size
from speaker setup menu
↑ ↓
move to new line
return to MAIN MENU
MENU
MENU4
return to USER PREFERENCE SETUP
MENU
MENU3
choose desired modeVOLUME KNOB
(REW) or
(FF)
2
move to Stereo Operation
∧
(UP) or
∨
(DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
23
p/n 12699 Rev. 9812C