Filter
Top Products
Setup your LFE channel - Usually this will be set to NORMAL. However, if you prefer less LFE you can reduce
the level or completely turn off the LFE channel. Note that this affects only the separate LFE channel available on
Dolby Digital and DTS material it has no effect on the reproduction of normal bass from the front, center, or rear
channels. If you have no subwoofer you may wish to reduce or turn off the LFE channel to reduce its contribution
to the bass going to your front speakers.
SPEAKER SIZE SETUP
1 Front L/R
2 Center
3 Rear L/R
4 Subwoofer
5 LFE
6 Center Delay
7 Rear Delay
adjust parameter
previous page
←→
MENU
↑ ↓
move to new line
Small
Small
Small
Yes
Normal
0 ms
0 ms
choose LFE settingVOLUME KNOB
(REW) or
(FF)
2
move to LFE
∧
(UP) or
∨
(DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
Set your delays for speaker placement - Ideally your front and center speakers will be the same distance away
from your listening area. If this is the case leave the Center Delay set to 0. However, physical limitations
sometimes require placing the center speaker closer than the front left and right speakers. The center delay
setting electronically “moves” the center speaker back into alignment with the front speakers. Measure the
distance in feet to your front speakers and to your center speaker. Subtract the center distance from the front
distance. Use this number for your delay setting (1 foot is roughly equal to 1 ms). If the result is negative set the
delay to zero. If the result is greater than 5 feet set the delay to 5 ms.
Ideally your front and rear speakers will be the same distance away from your listening area. If this is the case
leave the Rear Delay set to 0. However, physical limitations often require placing the rear speakers closer than the
front speakers. The rear delay setting electronically “moves” the rear speakers back into alignment with the front
speakers. Measure the distance in feet to your front speakers and to your rear speakers. Subtract the rear
distance from the front distance. Use this number for your delay setting (1 foot is roughly equal to 1 ms). If the
result is negative set the delay to zero. If the result is greater than 15 feet set the delay to 15 ms.
SPEAKER SIZE SETUP
1 Front L/R
2 Center
3 Rear L/R
4 Subwoofer
5 LFE
6 Center Delay
7 Rear Delay
adjust parameter
previous page
←→
MENU
↑ ↓
move to new line
Small
Small
Small
Yes
Normal
0 ms
0 ms
SPEAKER SIZE SETUP
1 Front L/R
2 Center
3 Rear L/R
4 Subwoofer
5 LFE
6 Center Delay
7 Rear Delay
adjust parameter
previous page
←→
MENU
↑ ↓
move to new line
Small
Small
Small
Yes
Normal
0 ms
0 ms
return to SETUP MENUS MENUMENU5
adjust Rear DelayVOLUME KNOB
(REW) or
(FF)
4
move to Rear Delay
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
3
adjust Center DelayVOLUME KNOB
(REW) or
(FF)
2
move to Center Delay
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
27
p/n 12699 Rev. 9812C