Filter
Top Products
MIDI FOOT CONTROLLER FCB1010
72. PROGRAMMING THE FCB1010
Fig. 2.2: PRESET selection with DIRECT SELECT enabled
As this example shows, the DIRECT SELECT feature gives
you a faster access to BANKS and PRESETS than without this
function. Which option to use is entirely up to you. As long as
you need the PRESETS from one BANK only, it will be advisable
to disable the DIRECT SELECT function because this way you
can recall a new preset with only one keystroke.
2.2 GLOBAL CONFIGURATION
In the GLOBAL CONFIGURATION menu you can set the
parameters that apply to both the PRESETS and FUNCTIONS of
your FCB1010 (e.g. MIDI channel selection, SYSEX SEND & RCV,
DIRECT SELECT etc.). Keep the DOWN switch pressed during
power-up for about 2.5 sec to enter GLOBAL CONFIGURATION
mode.
The DIRECT SELECT LED in the display lights up.
You can use the UP and DOWN keys to navigate through
GLOBAL CONFIGURATION main pages. Pressing UP leafs through
the pages forward, pressing DOWN leafs the pages backward.
A corresponding LED indicates what page you are on.
Fig. 2.3: GLOBAL CONFIGURATION menu structure
To leave GLOBAL CONFIGURATION menu, you need to press
the DOWN/ESCAPE key for at least 2.5 sec.
+ Only keeping the DOWN/ESCAPE key pressed for at
least 2.5 sec. saves your newly entered settings!
2.2.1 DIRECT SELECT page
Keep the DOWN/ESCAPE key pressed while you power up
the unit. This takes you to the GLOBAL CONFIGURATION menu;
the green DIRECT SELECT LED lights up. To activate DIRECT
SELECT, press 10/0 key. The red LED lights up. Now, you have
to confirm activating DIRECT SELECT to be able to directly select
presets. To do this, keep DOWN/ESCAPE pressed for 2.5 sec. to
exit GLOBAL CONFIGURATION. The display now shows 00.
Now you can directly select the presets, as described in ch.
2.1.2.
2.2.2 MIDI channel setting
To get from DIRECT SELECT to MIDI FUNCTION, press UP. The
MIDI FUNCTION LED flashes correspondingly.
This is where you determine the MIDI channels that can be
sent from the FCB1010 for various MIDI functions. You can assign
different MIDI channels to MIDI functions, For example, you can
control several pieces of equipment from your FCB1010. The
selection of MIDI functions is done via footswitches 1 to 10/0.
MIDI channel 1 is the factory default for all functions.
1 PRG CHG 1
2 PRG CHG 2
3 PRG CHG 3
4 PRG CHG 4
5 PRG CHG 5
6 CNT 1
7 CNT 2
8EXP A
9EXP B
10/0 NOTE
Tab. 2.1: Footswitches and assigned MIDI functions
s After selecting a MIDI function by pressing one of the
footswitches, the respective footswitch LED starts to blink.
s Press UP/ENTER to confirm the selected MIDI function. The
MIDI CHAN. LED lights up.
s Choose the MIDI channel for the selected function, either
directly via footswitches 1 through 10/0 or by using the
EXPRESSION PEDAL A. Your selection is shown in the
display.
s Press UP/ENTER to confirm the chosen value and to go to
the next level, or press DOWN/ESCAPE to cancel.
2.2.3 CONFIG page
The CONFIG LED lights up if you are on CONFIGURATION page.
The following functions, recalled via the footswitches (as in
table 2.2), are at your disposal: