Filter
Top Products
3
6
Powering the 1201BT Transmitter
The 1201BT uses 2 “AA” Alkaline batteries for power. The batteries are
placed in the battery compartment by sliding the battery compartment door
[ ] down and placing the batteries in the compartment as marked [ ]. DO
NOT FORCE THE BATTERIES INTO THE COMPARTMENT. Azden does not
recommend the use of rechargeable batteries.
**
r
SETTING THE TRANSMITTING FREQUENCY ON THE 1201BT
Before the 1201BT can be used, it and the associated receiver have to be set
to the same frequency. This can be accomplished on the 1201BT transmitter
by rst setting the LCD display to one of two views - ‘Frequency’ or ‘Channel’.
To do this, after installing fresh batteries, turn the 1201BT to the ON position
[ ]. Next, using the tip of a ballpoint pen, an unbent paper clip or something
similar, press the MODE button [ ] repeatedly until one of the two screens
below appears.
l
q
r
j
k
l
m n o
p
q
s
*
**