Filter
Top Products
POWERING THE 1201XT (continued)
in the illustration. The compartment is deigned to ease battery insertion - With
the correct polarity. DO NOT FORCE THE BATTERY INTO THE COMPART-
MENT. Azden does not recommend the use of rechargeable batteries.
SETTING THE TRANSMITTING FREQUENCY ON THE 1201XT
Before the 1201XT can be used, it and the associated receiver have to be set
to the same frequency. This can be accomplished on the 1201XT transmit-
ter by rst setting the LCD display to one of the two views - ‘Frequency’ or
‘Channel’. To do this ,after installing fresh batteries, turn the 1201XT to the
ON position [ ]. Next, using the tip of a ballpoint pen, an unbent paper clip
or something similar, press the MODE button [ ] repeatedly until one of the
two screens below appears.
r
n
Using either the UP or DOWN button [ ] the desired receiving frequency
or channel number can be set. Tapping the button steps the frequency or
channel number one at a time while pressing and holding the button in moves
through the frequencies or channel numbers rapidly. There are 188 different
frequencies or channel numbers to choose from. Once the desired frequency
or channel number has been determined be certain to set both the transmitter
and the receiver to match.
o
9
TABLE OF CONTENTS
1201URX SERIES RECEIVER VIEW ......................................................... i
INTRODUCTION ........................................................................................ ii
RECEIVER (1201URX/AB and 1201URX/VM) SETUP ..........................1-2
Attaching the Antennas ...............................................................................1
Connecting the Output Cable .....................................................................1
Setting the Receiver’s Frequency ...........................................................1-2
Power .........................................................................................................2
Output .........................................................................................................2
Monitor ........................................................................................................2
LCD Display .............................................................................................2-4
The 1201URX/Si .........................................................................................4
Mode ........................................................................................................4-5
Up/Down .....................................................................................................5
Powering the 1201BT Transmitter ..............................................................6
SETTING THE TRANSMITTING FREQUENCY ON THE 1201BT .........6-7
USING THE 1201BT TRANSMITTER’S CONTROLS AND DISPLAY ........7
Power .........................................................................................................7
Audio ..........................................................................................................7
MIC .............................................................................................................7
Input Level Adjustment ...............................................................................7
Belt Clip ......................................................................................................7
Antenna ......................................................................................................8
Display ........................................................................................................8
THE 1201XT ...............................................................................................8
Powering the 1201XT ..............................................................................8-9
SETTING THE TRANSMITTING FREQUENCY ON THE 1201XT ............9
USING THE 1201XT TRANSMITTER’S CONTROLS AND DISPLAY ......10
Power .......................................................................................................10
Audio ........................................................................................................10
MIC Connector / Locking Ring ..................................................................10
Input Level Adjustment .............................................................................10
Display ...................................................................................................... 11
SPECIFICATIONS .......................................................................Back Page
LICENSING .................................................................................Back Page
CONFORMITY ....................................................................................Insert
iii