Azden 1201BT Radio User Manual


 
1201URX/VM
1201URX/AB
s
E. Display
The LCD segments on the left show the approximate remaining battery
life (from 1 to 3 segments) with 3 segments meaning maximum battery power.
The bottom segment will blink when the battery power falls to less than
2.2VDC and indicates that it is time to replace the batteries. Azden recom-
mends the use of Alkaline batteries only.
Across the top of the display up to 5 segments will illuminate depending
on the strength of the transmitted audio signal - From 2 (weak) to 5 (strong).
The rst (left) segment will light when the AUDIO switch is turned ON. The
best audio is achieved when 4 to 5 segments are lit. If all 5 segments are
lit continually, the signal is too strong and could overload the input of the
receiver. Move the microphone further away from the sound source.
The display can also show the total number of hours of use (change
to this display using the mode [ ] button. To start, after choosing the TIME
mode, press the UP [ ] Button until the display shows 00:00. Then, each
time the transmitter is turned ON the clock will keep track of the total hours
and minutes used. This is a handy way of keeping track of battery life.
n
o
i 11
1201URX/VM
1201URX/AB
1201URX/Si
j
k
l
n
o
pq
r
s
j
j
k
j
l
p
p
o
o
s
r
r
q
n
s
In addition to showing the frequency and the channel number, the dis-
play [ ] also shows other useful information.
j