Filter
Top Products
TRACK M S F
TRACK M S F
TRACK M S F
TRACK M S F
TRACK M S F
TRACK M S F
TRACK M S F
TRACK M S F
©American Audio® - www.AmericanAudio.us - DCD-PRO210™ Instruction Manual Page 17
BASIC OPERATIONS (CONT)
1) Be sure a disc is inserted in the drive and press the
PROG Button (15). Pressing the PROG Button (5) from
any function will immediately pause the disc and enter the
program mode.
2) After activating the program mode the PROGRAM INDI-
CATOR LED will begin to glow indicating Program Mode
has been activated.
11. PROGRAM PLAY
This operation allows you to customize your disc playback. You may select specific tracks to played and the
order they will be played in. You may program a maximum of 20 tracks at once and program a single track to
played more than once. To create a program:
3) Select a track to be programmed by using
the FORWARD TRACK SKIP (11) and
BACK SKIP TRACK BUTTON (12).
4) Once you reach the track you wish to place into the
program memory press PROG Button (15). Doing this will
lock the track into memory.
Figure 17
Figure 16
5) Repeat steps three and four up to 19 times (up to 20 tracks may be programmed).
6) As you program tracks into memory, the LCD (4) will indicate how many tracks have been programmed.
7) When you have finished your programming and are ready
to begin playback simply press the PLAY/PAUSE
BUTTON (3) and your program will begin to play.
8) After you have complete your program you can
always add more tracks to your program by repeating
the steps one through four. Remember that you can only
a maximum of 20 track in a program and you can only
add track not subtract.
9) To cancel and clear the program press and hold down the
PROG Button(15) for more than two seconds, until the
LED light turns off.
Figure 18
Figure 15