Filter
Top Products
TRACK M S F
TRACK M S F
TRACK M S F
TRACK M S F
©American Audio® - www.AmericanAudio.us - DCD-PRO210™ Instruction Manual Page 15
8. CHANGING THE TIME DISPLAY (41, 42, & 43)/TIME BAR (35):
The time may be displayed in three different modes; Elapsed, Remain, and Total Remain. During normal play-
back, pressing the TIME BUTTON (13), will change the time display information (41, 42, & 43) in the LCD (4).
The following is a break down of the time settings and their definitions:
1) ELAPSED (36) - This details the time in the LCD (4) as the current tracks’ elapsed running time. The
elapsed function only details a tracks elapsed time and not the entire disc.
2) REMAIN (37) - This details the time in the LCD (4) as the current tracks’ remaining running time.
By pressing the button again, it will read the total disc remaining time.
TIME BAR INDICATOR - The time bar in the LCD (4) visually details the time defined in the TIME METER (41,
42, & 43). This bar is also dependent on the selected time function REMAIN (37) or ELAPSED (36). This bar will
begin to flash when 15 seconds of a track remain and will begin to rapidly flash when three seconds
of a track remain. The flashing bar is a great visual reminder a track is about to end. The flashing bar
will function regardless of which time mode the unit is in.
BASIC OPERATIONS (CONT)
Activating the Pitch Slider (5): To activate the
PITCH SLIDER (5), turn the pitch function on. Press
the PITCH BUTTON (9) to turn on the pitch function,
when the pitch function is activated a LED will begin
to glow. If the pitch function is not activated neither
the PITCH SLIDER (5) nor the PITCH BEND BUTTONS
(7 & 8) will function.
9. PITCH ADJUSTMENTS:
This function will increase or decrease a tracks playback speed or "PITCH," this is not a momentary change
as in "PITCH BENDING" (see page 16). The maximum pitch bend percentage of the PITCH SLIDER is +/-12%.
The PITCH SLIDER (5) is used to decrease or increase the playback pitch. If the slider is move up (towards the
top of the unit) the pitch will decrease, if the slider is moved down (towards the bottom of the unit) the pitch
will increase.
Using the Pitch Slider (5): To use the PITCH
SLIDER (5) slide the slider up and down. Down will
increase the pitch and up will decrease the pitch.
Figure 11
Figure 10