Filter
Top Products
MULTITASKER™
400-0209-002
23
23
Cause 2: The card settings are wrong.
Solution: Verify the card volume settings are
at maximum and that mute is off.
(See section 7). If no sound is
present, see Cause 3.
Cause 3: Cable connections are incorrect.
Solution: Make sure the cables are connected
properly and that the continuity and
wiring are good. If there is still no
sound present, see Cause 4.
Cause 4: The destination amplifier is bad.
Solution 1: Make sure that the destination
amplifier is powered. If there is still
no sound, see Solution 2
Solution 2: Set the volume of the destination
amplifier to a reasonable level. If
there is still no sound, call ALTINEX
at (714) 990-2300.
8.3 SOUND DISTORTION
Cause 1: Source level is above 1Vp-p.
Solution1: Verify the source level is below
1 Vp-p. If the sound is still distorted,
call ALTINEX at (714) 990-2300.
8.4 SOUND LEVEL IS LOW
Cause 1: Volume levels are inappropriate.
Solution 1: Turn up the source volume. If sound
level is still low, see Solution 2.
Solution 2: Increase the destination amplifier
volume. If the sound level is still low,
see Cause 2.
Cause 2: Poor signal transmission.
Solution: Check the cables for continuity.
Verify the connections are wired
properly and that there is good
signal transmission. NOTE: Test the
system by removing the card from
between the source and the
destination amplifier. If the problem
persists, call ALTINEX at
(714) 990-2300.
ALTINEX POLICY 9
9.1 LIMITED WARRANTY/RETURN POLICY
Please also see the Altinex website at
www.altinex.com for details the on warranty and
return policies.
9.2 CONTACT INFORMATION
ALTINEX, Inc.
592 Apollo Street
Brea, CA 92821 USA
TEL: 714 990-2300
TOLL FREE: 1-800-ALTINEX
FAX: 714-990-3303
WEB: www.altinex.com
E-MAIL: solutions@altinex.com