Filter
Top Products
MULTITASKER™
400-0209-002
22
22
2. Set Input 3 Volume
Starting from the Main Menu, set Input 3 volume
level to 16. Follow the keystrokes below.
2 Select SETUP Menu
2 Select Set Input Volume
3 Select Input 3 Volume
16 Enter 16
NOTE The system may echo the 1
and the 6 entries, depending
on the settings.
ESC Return to SETUP
ESC Return to the MAIN Menu
3. Set Output Volume
Starting from the Main Menu, set the output
volume level to 16. Follow the keystrokes below.
1 Select CONTROL Menu
4 Select VOLUME
1 Select OUTPUT volume
111… Press ‘1’ to increase volume level until
16 is reached.
ESC Return to VOLUME Menu
ESC Return to CONTROL menu
ESC Return to the MAIN Menu
4. Set Ramp Time
Starting from the main menu, set the ramp time
to 10 seconds. Follow the keystrokes below.
2 Select SETUP Menu
3 Select Set Ramp Time
4 Select Ramp Time = 10 seconds
ESC Return to SETUP menu
ESC Return to the MAIN Menu
5. Display Card Status
Starting from the Main Menu:
3 Displays card status
NOTE: The status will be displayed, followed
by the Main Menu being redisplayed.
TROUBLESHOOTING GUIDE 8
We have carefully tested and have found no
problems in the supplied MT113-100/101; however,
we would like to offer suggestions for the following:
8.1 FAN DOES NOT SPIN
Cause 1: Card cage is not plugged into
power outlet.
Solution: Plug card cage in. If the fan turns
on, the problem is solved. If the fan
is still not on, see Cause 2.
Cause 2: Card is not plugged in all the way.
Solution: Push the card in all the way. If the
fan still does not spin, see Cause 3.
Cause 3: Card cage slot has a problem.
Solution 1: Test the card in other slots. If the
slot was damaged, the card may
work in other slots. If other slots
work, and the fan is on, the problem
is the card cage slot. The card cage
may require service. Call ALTINEX
at (714) 990-2300. If other slots do
not work, see Solution 2.
Solution 2: Take any other known good card
with an LED or fan and verify that
the slot used is good by seeing if the
other card’s LED (or fan) turns on. If
so, then the original card may be the
source of the problem. Call
ALTINEX at (714) 990-2300.
8.2 NO SOUND
Cause 1: The source has a problem.
Solution Check the source and make sure
that it is working at an appropriate
volume level and all source
connections are correct. If the
source is working and there is still
no sound, see Cause 2.