Filter
Top Products
MULTITASKER™
400-0209-002
18
18
37. [HELP]
This command displays information available for
the MultiTasker interface commands.
Command Format: [HELPCnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
In order to display the RS-232 commands
available for the MT113-100/101 card in slot #2,
send the command [HELPC2]. The commands
along with a brief description will be displayed in
the Terminal Window.
38. [WR]
This command groups multiple cards in the
enclosure allowing all the group members to be
controlled simultaneously with the same
command. Each unit may define a maximum of
eight groups.
In MultiTasker systems with audio and video
cards, boards are typically grouped as follows:
Group 1 = Video Cards
Group 2 = Audio Cards
Group 3 = Video and Audio Cards
If assigning group commands to button
functions, it is best to use the "Press and Hold
on Power Up" to make group settings.
Command Format: [WRCn
1
Cn
2
…GkUi]
Cn = Card ID (n = slot # from 1 to max slots)
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
To group cards 1, 2, and 3 as group 5 of
Unit ID 1, send the command
[WRC1C2C3G5U1]. After executing this
command, cards 1, 2 and 3 will be grouped
together as group 5 of Unit ID 1. The system will
return the following feedback:
G1=C1C2C3
Now, when a command is sent to G1, each
board in G1 will execute the same command.
39. [RMC]
This command may be used to remove one or
more group members from a group. Reset the
system after using this command for all changes
to take effect.
Command Format: [RMCn
1
Cn
2
…GkUi]
Cn = Card ID (n= # from 1 to max slots)
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 1 consists of the cards located in slots
numbered 1, 2, 3, 4 and 5. Remove just cards
#4 and #5 from the group by sending the
command [RMC4C5G1]. The system will return
the following feedback:
G1=C1C2C3
40. [RMG]
This command may be used to delete an entire
group, or all groups.
REMOVE ONE GROUP MEMBERS
Remove all the members from the group,
effectively deleting the group.
Command Format: [RMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 1 consists of the cards located in slots
number 1, 2 and 3. Remove all cards from the
group by sending the command [RMG1]. The
system will return the following feedback:
G1=EMPTY