Filter
Top Products
51-EN
• Avoid stopping, pausing, switching the disc, cueing, fast-
forwarding or switching the audio channel of this unit while
making this adjustment. The setting is canceled if the Decode mode
is switched.
• This adjustment is ineffective when the speaker is set to CENTER
OFF in “Setting the Speaker” (page 45).
• This function only works with two-channel signals. This operation
is ineffective when 5.1-channel DTS or Dolby Digital signals are
input.
• If the setting of REAR FILL is made when REAR MIX is ON, sound
is unchanged in the rear fill setting because REAR MIX is given
priority during 2 channel decoder other than linear PCM.
• For linear PCM signals, the voice is output from the rear speaker
regardless of the REAR FILL and REAR MIX setting.
Linear PCM Setting
The output when playing discs recorded in linear PCM can
be set to 2 or 3 channels.
1
Check that Defeat mode is off.
2
Press SOURCE/POWER.
The main menu is displayed.
3
Press 4 (A.PROC).
A.PROC (Audio processor) list display appears.
4
Turn the Rotary encoder to select "PCM MODE".
The Function Guide changes.
5
Press 1 (2CH) or 2 (3CH).
2CH: 2ch output (L/R)
3CH: 3ch output (L/R/CENTER)
• This adjustment is ineffective when the speaker is set to CENTER
OFF in “Setting the Speaker” (page 45).
Using the ProLogic II Mode
Pro Logic processing can be conducted on the music signals recorded
on two channels to achieve Dolby Pro Logic II surround sound. For
two-channel Dolby Digital and DTS signals, there is also a “REAR
FILL” function for outputting the signals of the front channel to the
rear channel.
1
Check that Defeat mode is off.
2
Press SOURCE/POWER.
The main menu is displayed.
3
Press 4 (A.PROC).
The A.PROC (Audio processor) list display appears.
4
Turn the Rotary encoder to select “DOLBY PL II.”
The Function Guide changes.
5
Press 1 (SETUP).
The DOLBY PL II adjustment display appears.
6
Turn the Rotary encoder to select DOLBY PL II.
7
Press the function button to select your desired
mode.
PL II MOVIE:
Suits the stereo TV shows and all programs
encoded in Dolby Surround. It improves the sound
field directivity to near that of discrete 5.1-channel
sound.
PL II MUSIC:
Can be used for all stereo music recordings, and
provides a wide, deep sound field.
REAR FILL:
Depending on the input signals, the sound may only
be output from the front speakers. In this case, the
"REAR FILL" function can be used to output signals
from the rear speakers as well.
OFF: Turns DOLBY PL II function to OFF.
If PL II MUSIC is selected, the center width can be adjusted
with following operations.
This function offers the optimum vocal position by adjusting
the center channel position between the center speaker and
the L/R speaker. (The adjustments established in “Adjusting
the acoustic image” (page 49) are ineffective while this
function is activated.)
1 Turn the Rotary encoder to select CENTER WIDTH
CONT.
The Function Guide changes.
2 Press 2 (ON).
By pressing 1 (OFF), the CENTER WIDTH CONT
function is turned to OFF.
3 Press 3 (LEVEL ;DN) or 4 (LEVEL UP :) to adjust
the level.
The level can be adjusted between 0 to 7. When the
level increases, the center channel position moves from
the center speaker position to both sides.
• This adjustment is effective when the setting of the center
speaker is SMALL or LARGE in the speaker setup settings.