Filter
Top Products
50-EN
Adjusting the DVD Level
The volume (signal level) for Dolby Digital, Dolby PL II, DTS and
PCM modes can be set.
• Avoid stopping, pausing, switching the disc, cueing, fast-
forwarding or switching the audio channel of this unit while
making this adjustment. The setting is canceled if the Decode mode
is switched.
1
Check that Defeat mode is off.
2
Press SOURCE/POWER.
The main menu is displayed.
3
Press 4 (A.PROC).
The A.PROC (Audio processor) list display appears.
4
Turn the Rotary encoder to select “DVD LEVEL.”
5
Press 1 (SETUP).
The DVD LEVEL list display appears.
6
Turn the Rotary encoder to select a mode to be
adjusted.
7
Press 1 (LEVEL ;DN) or 2 (LEVEL UP :) to
adjust the level.
The level can be adjusted in the range of –5 to +5.
Storing Settings in the Memory
Adjustment or setting contents can be stored.
Contents that can be stored vary depends on the audio processor used.
1
Check that Defeat mode is off.
2
Press SOURCE/POWER.
The main menu is displayed.
3
Press 4 (A.PROC).
The A.PROC (Audio processor) list display appears.
4
Turn the Rotary encoder to select “PRESET
MEMORY.”
The Function Guide changes.
5
Press one of 1 (P.SET1) to 6 (P.SET6) for more
than 2 seconds.
The setting contents are stored.
• The stored contents will not be deleted even when the battery
power cord is detached.
Getting out the Preset Memory
1
Check that Defeat mode is off.
2
Press SOURCE/POWER.
The main menu is displayed.
3
Press 4 (A.PROC).
The A.PROC (Audio processor) list display appears.
4
Turn the Rotary encoder to select “PRESET
MEMORY.”
The Function Guide changes.
5
Press one of 1 (P.SET1) to 6 (P.SET6) to select
the preset memory you want to get out.
• It takes a few moment to get out the preset memory.
6
5
4
3
2
1
SOURCE/POWER
Rotary encoder
Adjusting the speaker levels
The test tones help to make the volume adjustments of the different
speakers. When levels are equal, a strong sense of presence can be
heard from the different speakers at the listening position.
• Avoid stopping, pausing, switching the disc, cueing, fast-
forwarding or switching the audio channel of this unit while
making this adjustment. The setting is canceled if the decode mode
is switched.
1 Turn the Rotary encoder to select OUTPUT LEVEL.
2 Press 1 (AUTO).
Test tone output is repeated for each of the different
speaker channels. They will be repeated in the order
shown below.
If no operation is performed for 2 seconds, the channel
switches to the next channel.
Left → Center → Right → Right Surround →
Left surround → Left
3 While the test tones are being produced from the
speakers, press 2 (LEVEL ; DN) or 3 (LEVEL UP
:) to adjust so that the volume of the different speakers
is equal.
• The adjustment range for the different speakers is
–10 dB - +10 dB.
• Adjust based on the front speakers.
• If a speaker is set to off mode, that speaker’s level adjustment
cannot be made.
Refer to “Speaker Setup” (page 48).