Filter
Top Products
Additional Information
23
GB
No sound or only a very low-level
sound is heard from the surround
speakers.
, Make sure a proper sound field function is
selected (page 15).
, Adjust the speaker volume (page 14).
The remote does not function.
, Remove any obstacles between the remote
and the system.
, Use the remote near the system.
, Point the remote at the remote sensor on
the system.
, Replace all the batteries in the remote with
new ones if they are weak.
The system does not operate
properly.
, Static electricity, etc., may affect the system’s
operation. Disconnect the AC power cord
(mains lead) once, then connect it again.
USB connection
The computer does not recognize
this system.
, Make sure the system is connected to the
computer with the supplied USB cable.
, It is recommended to connect the USB cable
directly to the USB port of the computer.
There is no sound.
, “Mute” is selected in the Volume Control
window. Open the Volume Control window
and cancel “mute.”
, The volume level is low, open the Volume
Control window and adjust the volume.
, Open the Sound and Multimedia Properties
window and click the Audio tab. Select this
system as the preferred device.
There is no sound from 5.1ch sound
, Select any sound field other than “H-T” or
“2CH” when using “WinDVD.”
, Check the output setting of “WinDVD” is set
correctly (page 20).
, The number of channel your computer
outputs using “WinDVD” vary depends on
the disc.
There is no sound from Audio CD.
, If the CD-ROM drive is not compliant with
digital audio output, the sound from the CD-
ROM drive will not be output via the USB
connection. In this case, connect the audio
output of the CD-ROM drive (e.g., the
headphones output) to the ANALOG IN jacks
and adjust the volume appropriately.
, If you use Windows 98 SE, confirm the
setting of the audio device.
1 Open the Control Panel window.
2 Open the Multimedia window and select
the USB audio device as the preferred
device for sound playback.
3 Select the CD Music tab. If the computer
has more than one CD-ROM drive, play
back a music CD. Select the drive and
check “Enable digital CD audio for this
CD-ROM device.”
The sound is interrupted.
, The sound may be interrupted if other USB
devices are connected or disconnected.
, If your computer does not meet the system
requirements, it may not perform well.
Besides, even if your computer meets the
system requirements, the sound may be
interrupted if the computer is under load. In
this case, shut down other applications.
Returning to the default settings.
While the power is off (the ?/1 (POWER)
indicator lights up red), press ?/1 (POWER) for 5
seconds until “INI” appears in the display.