Filter
Top Products
49
Connecting the Net MD to your computer
After the software installation is completed, connect the Net MD to your computer.
Refer to the operating instructions of the Net MD as well.
1 Insert a recordable disc into the Net MD.
2 Make the power source and the dedicated USB cable connections with the Net
MD and the computer.
3 Check the connections.
When the connections have been properly made, “PCppMD”* appears in the display
of the Net MD.
* Depending on the device, “Net MD” or “PC>>MD” may be displayed.
Notes
• When using the Net MD connected to your computer, make sure to run the recorder from an AC
outlet. We do not assure the results should there be a mis-operation, check-out failure, or destruction
of audio data caused by insufficient battery power.
• Place the recorder on a stable surface so that the dedicated USB cable does not become detached.
Net MD
devices*
Dedicated
USB cable
To the USB
connecting
terminal
To the USB jack/
dedicated jack
Computer
* If a cradle is supplied with your Net MD, connect the dedicated USB cable to the
USB cradle and place the Net MD onto the USB cradle.
To the DC IN
jack
AC
power
adaptor