Filter
Top Products
38
The recorder does
not work or works
poorly.
• The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. Rerecord the disc. If the error message still
appears, replace it with another disc.
• There is an internal malfunction in the system.
, Remove the dedicated USB cable from the recorder, restart
your computer, and then connect the cable to the recorder
again.
• While operating, the recorder received a mechanical shock, too
much static, abnormal power voltage caused by lightning, etc.
, Restart the operation as follows.
1 Disconnect all the power sources.
2 Leave the recorder for about 30 seconds.
3 Connect the power source.
The display
window is not
normal.
• The recorder was disconnected from the power source.
, Let the recorder sit for a while, or disconnect the power source,
reconnect it, and then press any of the operation buttons.
When using with
the AC power
adaptor, the display
window of the
recorder will
remain faintly lit
for some time even
after the recorder is
stopped.
• This is due to the MiniDisc system limitation. The recorder turns
off 10 senconds after the recorder has stopped in order to allow the
charging time on the dedicated USB cradle to be calculated.
The playing time of
a checked-out track
is different from
the time that
appears on your
computer monitor.
This is due to a calculation discrepancy between the recorder and
the computer.
Symptom Cause/Remedy