Filter
Top Products
To stand the AM antenna on a surface
Fix the claw to the slot.
BEFORE OPERATION
I
b PRESET
:,, ,,, ,,-;
...,.
SHIFT
FUNCTION
To turn the unit on
Press one of the function buttons (TAPE, TUNER, VIDEO/AUX,
CD). The unit is turned on.
At this time, playback of the inserted disc begins, or the previously
tuned station is received (Direct Play Function).
The POWER button is also available to turn the unit on.
m
The disc compartment may open and close to reset the unit,
when the unit is turned on.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
DEMO (Demonstration) mode
When the AC cord is connected for the first time, the display
window demonstrates the functions of the unit. When the power
is turned on, the DEMO display is overridden by the operation
display.
To cancel DEMO mode
Press the 11 SET button while the power is off. In this time, the
clock on the display appears. (To set the current time, see
“SETTING THE CLOCK on page 11.)
To restore the DEMO mode, press the E PRESET button while
the power is off.
Using the headphones
Flash window
The window on the top of the unit lights up or flashes while the
unit is being powered on,
To turn off the light, press the CD button while pressing the
■ CLEAR button. To turn back on, repeat the above.
To use the SHIFT button on the remote control
Buttons @ have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
Touse the function on the plate above the button, press the button
while pressing the SHIFT button.
To use the FUNCTION button on the remote control
The FUNCTION button substitutes for the function buttons (TAPE, ‘--
TUNER, ViDEO/AUX,CD) on the main unit.
Each time the FUNCTION button is pressed, the next function is
selected cyclically.
Inserting batteries into the remote control
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
m
with new ones.
m
● If the unit is not going to be used for an extended period of
time, remove the batteries from the remote control to prevent
possible electrolyte leakage.
● The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (television, etc.)
Connect headphones to the PHONES jacks with a stereo
standard plug (@6.3mm,
‘/4 inch).
No sound isoutput from the speakers while the headphones are
plugged in,
ENGLISH 4