Filter
Top Products
SETTING THE CLOCK
1
1
2
3
2,3
IL
,,—.
. .-—
I c) d}-;
——..—
,_
Press the CLOCK button while pressing the
SHIFT button on the remote control, and press
the 11
SET button within 4 seconds.
The hour flashes.
Press the l+< DOWN or WI UP button to
designate the hour, and press the II SET button.
The hour stops flashing and the minute starts flashing.
Press
the M DOWN or M UP button to
designate the minute, and press the II SET
button.
The minute stops flashing on the display and the clock starts
from 00 second.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The clock is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the
CLOCK button while pressing the SHIFT button on
~heremote control and then press the ■ button within 4 seconds.
‘Repeat the same procedure to restore the 12-hour standard.
[f the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase may need to be
reset.
SETTING THE TIMER
1
6
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
Press-the TIMER button on the remote, control
while pressing the SHIFT button once to display
0, and press the 1I SET button within 4 seconds.
O is
displayed; and the hour flashes:
If you do not press the II SET button within 4 seconds,
another operation may start.
Designate the hour of the timer-on time by
pressing the - DOWN or W UP button, and
the II SET button. Repeat to designate the minute
of the timer-on time.
After you designate the timer-on time, TIMER and one of the
source name flashes alternately on the display for 4 seconds.
Within 4 seconds, press one of the function
buttons to select a source.
“TIMER” and the selected source name flash alternately for
4 seconds.
● If this step is not completed within 4 seconds, repeat from
step 1.
● IftheTUNER buttonispressed,the bandcannotbe selected
inthis step.