Filter
Top Products
For example, if the m1 button is programmed in
Group 1 mode to turn on the TV, turn on the audio
receiver, turn on the VCR, and then turn on the
satellite receiver, it will perform the same series of
commands whenever the m1 button is pressed IF
main, vid 1, vid 2, or vid 3 sources are selected at
the time you select that macro. If you’ve pro-
grammed a Group 2 macro, it will send out an iden-
tical command sequence whenever vid 4, vid 5,
tuner, or CD inputs are selected.
Programming Macro Initiator Buttons:
1. Press either the Group 1 or Group 2 source selec-
tor button (main or vid 4 respectively) and the mute
button simultaneously. Hold both buttons until the
red status LED and the input selector button remain
lighted.
2. Press the macro initiator button (power, m1, m2,
m3 or m4) you wish to program.
3. Select and press up to 10 buttons you wish to
store in the macro. Both source selector and
function buttons count as individual commands.
Remember that each macro can hold only up to 10
individual commands.
4. Press the tuning up button to save the macro.
The red status LED and input selector button will
blink twice to confirm programming and then turn off.
Please note:
• To add a power (on/off) command to the macro,
use the mute button in place of the power button.
• The tuning up/down buttons cannot be used in a
macro sequence.
Deleting Macro Initiator Buttons:
1. Press either the Group 1 or Group 2 source selec-
tor button (main or vid 4 respectively) and the mute
button simultaneously. Hold both buttons until the
red status LED and the input selector button remain
lighted.
2. Press the macro initiator button (power, m1, m2,
m3 or m4) you wish to delete.
3. Press the tuning up button. The red status LED
and input selector button will blink twice to confirm
deletion of the macro.
GTP-830 DIGITAL PROCESSING TUNER/PREAMPLIFIER
28 | ADCOM OWNER’S MANUAL