Filter
Top Products
AVR350
30
Bi-wiring and bi-amping loudspeakers
Bi-wiring improves the sound of your system as it divides the high and low frequency signal currents into
separate speaker cables. The performance of your system can be further enhanced over that achieved
with bi-wiring by extending the principle one stage further to include separate amplication for the low
and high frequency drive units in each loudspeaker enclosure. This is called ‘bi-amping’.
Before you start – important information!
1. Ensure that the volume control is set to minimum before starting these procedures.
2. Do not make any connections to your AVR350 while it is switched on or connected to the
mains supply.
3. After connecting the loudspeakers, but before switching on the AVR350, please check all
connections thoroughly, making sure bare wires or cables are not touching the AVR350 in
the wrong places (which could cause short circuits) and that you have connected positive
(+) to positive and negative (–) to negative.
Bi-wiring your loudspeakers
Bi-wiring avoids signal distortions arising from the high and low frequency currents interacting
with one another within a single cable, as occurs in conventionally wired systems.
You will need:
Speakers – with four input terminals each: the terminals will be marked HF (High Frequency
+ and –) and LF (Low Frequency + and –).
Loudspeaker cables – two pairs of cables per loudspeaker.
How to bi-wire loudspeakers
1. Remove the terminal links on the rear of your loudspeakers.
NOTE: If you do not remove the shorting links from the speaker terminals, the speakers
will still be single-wired!
2. Connect the cables as shown in the diagram, ensuring correct polarity at all times.
Bi-amping your system
Notes:
<
In order to bi-amplify your speakers, your speakers will need to be bi-wirable (have
positive and negative terminals for both high frequency (HF) and low frequency (LF)
information). If your speakers are bi-wirable, ensure that the links between the HF and LF
terminals are removed.
WARNING: This step is essential or damage to
your AVR350 may result which is not covered
under warranty.
<
If you wish to bi-amplify speakers using external
power ampliers, you must use ampliers with the
same gain as the AVR350 (31dB), otherwise the
bass and the treble will become unbalanced. Please
contact your dealer if you require more information
on bi-amping your speakers.
Bi-amping using the AVR350
If channels 6 and 7 of your system are not in use (i.e., you
have a system comprised of a maximum of ve speakers,
excluding the subwoofer), these spare amplication channels
may be used to bi-amplify the front left and right speakers of
your system.
Follow these steps:
1. Remove the terminal links on the rear of your
loudspeakers.
WARNING: This step is essential or damage to
your AVR350 may result which is not covered
under warranty.
2. Connect the cables as shown in the diagram below,
ensuring correct polarity at all times.
3. Ensure that the
USE CHANNELS 6+7 for setting in
Basic menu 6 ‘EX Settings’ is set to
BIAMP L+R. (See
page 13 for details of how to do this.)
Bi-wiring using the
AVR350 (only one speaker
is shown, for clarity)
Left
speaker
Right
speaker
Bi-amping using the surround back channels of the
AVR350 (only the front left and right speakers
are shown, for clarity)