Filter
Top Products
Page 8
LOCATING A BURIED CABLE
Receiver Setup
Note: Key descriptions can be found on the side of the Receiver.
Press
to turn the Receiver on.
Press to select the 50/60 Hz power frequency (see section on
Selecting Passive Power Frequencies Page 9) or LF for passive locating;
otherwise, select the same frequency as the Transmitter.
Note: The Receiver is automatically set to Special Peak mode when LF is
selected. No other modes are allowed in LF frequency.
Press to adjust the speaker volume as needed: off, normal, high, or
high-expanded. The high-expanded setting causes the audio to cut off as
the antenna moves away from the cable.
Note: While tracing cables, keep the Receiver handle in line with the
suspected cable path.
To select Special Peak mode, press and hold the press .
While in this mode, the peak flag will flash.
Note: Peak or Special Peak mode may require re-setting the Receiver
gain. Press
when the bar graph remains either fully open or fully
closed.