Filter
Top Products
Page 6
Connect the Dyna-Coupler to the Transmitter front panel jack using the
coupler cable.
Clamp the Dyna-Coupler around the cable below any bonds just before the
cable enters the earth. The jaws of the coupler must fully close.
Press to apply Tracing signal and select the 33 kHz frequency. LED
indicates frequency selection. (This key can also turn the unit on.)
Select high output level by pressing .
Transmitter setup is finished, now go to LOCATING A BURIED CABLE
- Receiver Setup (Page 8).
Dyna Coupler Method