7-24 Programmer’s Manual
Message Solution
Could not get the file. Verify that a valid PC/printer
connection exists. If so, verify the
syntax of the command and retry it.
Could not put the file. Verify that a valid PC/printer
connection exists. If so, verify the
syntax of the command. Then, retry
the command.
Could not remove directory: Verify that the directory you specified
exists and retry the command.
Could not save file locally. There is not enough space on the PC
to save a file received from the
printer. Free some space and retry
the command.
Did not receive a response from
the Ultra.
Verify that a valid PC/printer
connection exists. If so, increase the
length of the timeout. Then retry the
command.
From the user perspective, a
command may finish running, but
there can still be processing going
on behind the scenes before the
command is truly finished. A timeout
can occur during this timeframe.
Therefore, when a timeout error
occurs, check to see if the command
actually finished or not before trying
to correct the problem. For example,
if the error occurred on a put, verify
that the file copy completed.
Error Running command on
Ultra. Returned Error = xxx
A ROM-DOS error occurred on the
printer. Retry the command. If the
same error occurs, re-boot the
printer and/or have it serviced.
