PagePrinter Network Adapter: Utilities & Environments 4-1
CHAPTER
Windows NT
operating
systems
4
Using Windows NT operating systems
Introduction Thank you for buying this multi-protocol adapter.
This chapter explains how to set up and use your printer on Windows NT
operating systems.
To do this, you should have a basic working knowledge of Windows NT.
How to print
The following methods are used to print in a Windows NT environment.
Windows NT 3.51:
(1) printing using the lpr protocol
Windows NT 4.0:
(1) printing using the lpr protocol
(2) printing using the Network Port (TCP/IP ports)
Before you begin
Before you can use the adapter, you need to set it up. Setup involves a few
simple steps:
1. Checking the physical connections.
2. Printing a setup page to use while you set up the adapter.
3. Setting the adapter’s IP address, netmask, and gateway.
4. Verifying the setup.
If you need help, see “Using TCP/IP networks” on page 2-1.
Printing under
Windows NT 3.51
This section explains how to create your printer under Windows NT 3.51
operating systems.
