A SERVICE OF

logo

Open as PDF
next previous
Repair information 4-41
5021-0XX
Main drive gear assembly removal
1. Remove cleaning roller clutch. See “Toner sensor (sender)
removal” on page 4-35.
2. Remove main motor assembly. See “Main motor assembly
removal” on page 4-38.
Note: If you are removing the main drive gear assembly to get to
the waste toner feeder you do not have to remove the fuser, transfer
roller, registration, or paper feed clutch. The clutches are removed at
the first of this procedure because the main drive gear assembly
FRU does not include the clutches.
3. Remove fuser clutch. See “Clutch removal” on page 4-40.
4. Remove transfer roller clutch. See “Clutch removal” on
page 4-40.
5. Remove registration clutch. See “Clutch removal” on
page 4-40.
6. Remove paper feed clutch. See “Clutch removal” on
page 4-40.
7. Remove five screws (A) that secure main drive gear assembly
to printer.
A