Filter
Top Products
23
English
CONNECTIONS
PREPARATION
If you are using 6 ohm speakers, set the impedance to 6
ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1 On the front panel, while pressing down
SPEAKERS A, press STANDBY/ON.
“SP IMP.SET” appears on the front panel display for
a few seconds, then “Minimum 8ohms” appears.
2 Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3 Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
y
You can also use SP IMP.SET (see page 57) to set the speaker
impedance.
When all connections are complete, turn on the power of
this unit.
1 Press STANDBY/ON (SYSTEM POWER on the
remote control) to turn on the power of this
unit.
2 Turn on the video monitor connected to this
unit.
Speaker impedance setting
CAUTION
SPEAKERS
A
STANDBY
/ON
SP IMP.SET
Minimum 8ohms
Turning on the power
VOLUME
VIDEO AUXSILENT
SPEAKERS
INPUT
MULTI CH
INPUT
INPUT MODE
PRESET
/
TUNING
PHONES
A/B/C/D/E
S VIDEO
MEMORY
FM/AM
EDIT
PRESET
/TUNING
MAN'L/AUTO FM AUTO/MAN'L MONO
TUNING
MODE
VIDEO AUDIO OPTICALLR
STANDBY
/
ON
A B
OPTIMIZER
MIC
TONE CONTROL
PROGRAM
STRAIGHT
EFFECT
TUNER
DSP
1
PHONO
POWER SLEEP
CLEAR
LEARN
STANDBY
TRANSMIT
RE–NAME
INPUT MODE
SYSTEM
V
-
AUX
DTV
POWER
REC
POWER
AMP
AVTV
DVR/VCR2VCR 1 DVD
SELECT
CBL/SAT MD/TAPE CD-R
TUNER
MULTI CH IN
CD
1
(U.S.A. model)
STANDBY
/ON
POWER
SYSTEM
or
Front panel
Remote control
00_RX-V1400U_EN.book Page 23 Thursday, February 19, 2004 4:26 PM