Filter
Top Products
32
CONNECTING THE FRONT EFFECT SPEAKERS,
REAR SPEAKERS AND THE CENTER SPEAKER(S)
TO THIS UNIT
Connect the FRONT effect speakers to the FRONT EFFECT
SPEAKERS terminals of this unit.
If the FRONT effect speakers are not used, the FRONT MIX
switch should be set to “ON”.
Connect the REAR speakers to the REAR SPEAKERS
terminals of this unit.
Connect the CENTER speaker to the CENTER SPEAKERS
terminals. If you will be using one CENTER speaker, connect it to
either the C or D terminals and set the CENTER speaker switch so
that it is released outward (“C OR D” position). If using two
CENTER speakers, connect them to the C and D terminals, and
press the switch inward (“C +D” position). If, however, you will not
be using a CENTER speaker, be sure to set the CENTER
SPEAKER mode to “PHNTM” (phantom). (See page 35.)
NOTE: The speaker connections above are fine for most
applications. If for some reason, however, you wish to use an
external power amp for any or all of the front effect, rear and center
channels, connect the line level output jack(s) for each channel to
the INPUT jacks of the external amp and connect the
corresponding speaker pair to the speaker terminals of the
external amp.
LR
LR
Center speaker
Center speaker
Center speaker
Front effect
speaker
Front effect
speaker
Rear speaker
Rear speaker
This unit