Filter
Top Products
CONTROLS AND FUNCTIONS
5 En
INTRODUCTION
9 PRESET j / i
Selects a preset FM/AM station when TUNER is selected
as the input source (see page 24).
Selects a preset SIRIUS channel when SIRIUS is selected
as the input source (see page 31).
0 FM/CATEGORY l, AM/CATEGORY h
Sets the FM/AM tuner band to FM or AM when TUNER
is selected as the input source (see page 20).
Selects a channel category when SIRIUS is selected as the
input source (see page 29).
A TUNING/CH jj / ii
Selects the tuning frequency when TUNER is selected as
the input source (see page 20).
Searches for a SIRIUS channel when SIRIUS is selected
as the input source (see page 29).
B Remote control sensor
Receives infrared signals from the remote control.
Switch the remote control ID between ID1 and ID2 when using
multiple Yamaha receivers or amplifiers (see page 44).
C ZONE 2
Turns on Zone 2 or sets ZONE 2 to standby mode. When
Zone 2 is turned on, signals are output to the ZONE 2
OUT jacks (see page 45).
D ZONE 2 CONTROL
Allows buttons and controls on the front panel to be used
to control Zone 2. For more information about controlling
Zone 2, see page 46.
E CD DIRECT AMP and indicator (R-S700 only)
Allows you to listen to a CD source in the purest possible
sound (see page 17). The indicator lights up and the front
panel display turns off when this function is turned on.
• If both the CD DIRECT AMP and the PURE DIRECT are
turned on, only the CD DIRECT AMP will function.
• Zone 2 cannot be used while this function is turned on.
F PURE DIRECT and indicator
Allows you to listen to a source in the purest possible
sound (see page 17). The indicator above it lights up and
the front panel display turns off when this function is
turned on.
Zone 2 cannot be used while this function is turned on.
G PHONES jack
Outputs audio to your headphones for private listening.
Press SPEAKER A/B so that the SP A/B indicators turn off
before you connect your headphones to the PHONES jack.
H REC OUT selector
Selects a source for recording to a CD recorder or to a tape
deck independently of the INPUT selector setting,
allowing you to record the selected source while listening
to another source (see page 19).
I BASS control
Increases or decreases the low frequency response. The
center position produces a flat response (see page 18).
J TREBLE control
Increases or decreases the high frequency response. The
center position produces a flat response (see page 18).
K BALANCE control
Adjusts the sound output balance of the left and right
speakers to compensate for sound imbalances caused by
speaker locations or listening room conditions (see page
18).
L LOUDNESS control
Retains a full tonal range at any volume level to
compensate for the human ears’ loss of sensitivity to high
and low-frequency ranges at a low volume level (see page
18).
M INPUT selector
Selects the input source you want to listen to.
N VOLUME control ( R-S700 only)
Increases or decreases the sound output level.
This does not affect the output level of the REC jacks.
Note
Notes
Note
Note
Note