Yamaha HTR-5940 Stereo Receiver User Manual


 
25
CONNECTIONS
PREPARATION
If you are to use 4 or 6 ohm speakers, set “SP
IMP.” to “6MIN” as follows BEFORE using this
unit.
1 Make sure this unit is set to the standby
mode.
See page 26 for details about turning on this unit or
standby mode.
2 Press and hold STRAIGHT (EFFECT) on the
front panel and then press STANDBY/ON to
turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3 Press PROGRAM l / h buttons on the front
panel to select “SP IMP.”.
The following display appears in the front panel
display.
4 Press STRAIGHT (EFFECT) on the front
panel repeatedly to select “6MIN”.
The following display appears in the front panel
display.
5 Press STANDBY/ON on the front panel to
save the new setting and set this unit to the
standby mode.
The setting you made is reflected next time you turn on this unit.
Setting the speaker impedance
CAUTION
VOLUME
AUTO/MAN'LMAN'L/AUTO FMLEVELNEXT
EDIT
EFFECT
MEMORY
FM/AM
PRESET/TUNING
A/B/C/D/E
l PROGRAM h
BASS/TREBLE
l
PRESET/TUNING/CH
h
TUNING MODE
INPUT MODE
TONE CONTROL
STRAIGHT
SPEAKERS
PHONES
SILENT CINEMA
STANDBY
/ON
BA
MULTI CH
INPUT
INPUT
SEARCH MODE
DISPLAY
CATEGORY
VIDEO PORTABLEL AUDIO R
VIDEO AUX
3
2,4
2,5
(U.S.A. model)
EFFECT
STRAIGHT
STANDBY
/ON
While holding
down
Note
l PROGRAM h
SP IMP.-8 MIN
EFFECT
STRAIGHT
SP IMP.-6 MIN
STANDBY
/ON