English
E-5
Ⅵ Mounting the main/rear/center speakers (and rear center
speaker for NS-P436) on the wall
You can mount the main, rear and/or center speakers (and/
or rear center speaker for NS-P436) on a wall.
To mount the speakers on a wall, use the holes of the
brackets attached on the speakers’ back panels.
1 Fasten two screws into a firm wall or wall support at the
interval shown below.
Main/rear/rear center (for NS-P436) .......... 26 mm (1”)
Center ............................................. 222.8 mm (8-3/4”)
2 Hang the speaker by mounting the holes on the
protruding screws.
* Make sure that the screws are securely affixed by the
narrow parts of the holes.
WARNING
● Each speaker weighs as follows.
Main/rear/rear center (for NS-P436)
...................................................... 1.2 kg (2 lbs. 10 oz.)
Center .......................................... 1.7 kg (3 lbs. 12 oz.)
Do not mount them on thin plywood or a wall
composed of a soft surface material. If mounted, the
screws may pull out of the flimsy surface and the
speakers may fall. This may damage the speakers or
cause personal injury.
● Do not affix the speakers to a wall using nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause the speakers to
fall.
● To avoid accidents resulting from tripping over loose
speaker cables, fix the cables to the wall.
● Select an appropriate position on the wall to mount
the speaker so that no one will injure his/her head or
face.
1
26 mm
Holes
2
Wall/ wall support
Tapping screw
(Available at the
hardware store)
Min.
20 mm
Diam. 3.5 to 4 mm
4 mm
Main/rear/rear center (for NS-P436)
Center
222.8 mm
Main/rear/rear center (for NS-P436)
Center
NS-P430-436 (UB) 03.2.28, 7:02 PM5