Filter
Top Products
69
ZONE 2/ZONE 3 (U.S.A., CANADA AND AUSTRALIA MODELS ONLY)
ADVANCED
OPERATION
Using this unit’s internal amplifier
To use this unit’s internal amplifier, select ON in ZONE2 AMP.
The supplied remote control can be used to control Zone
2/Zone 3. You can even select the input source and control
components located in the main room directly from the
second room regardless of the listening condition in the
main room.
■ To enable Zone mode on the remote
control
You will be able to switch the remote control mode from
one room to another, and use STANDBY, SYSTEM
POWER, MUTE and VOL –/+ to control the selected
room.
1 Repeat steps 1 and 2 of the procedure in
“Setting manufacturer codes” on page 60.
2 Press j / i to select “L:AMP”.
3 Press u / d to select “ZONE”.
4 Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit,
Zone 2 or Zone 3.
■ To control Zone 2/Zone 3
1 Press SELECT k repeatedly to display
“ZONE2” or “ZONE3” in the display window.
2 Press SYSTEM POWER to turn Zone 2 or
Zone 3 power on.
3 Press an input selector button to select the
input source you want to listen to in the
second/third room.
The display window shows “2: name of selected
input” if the remote control is in the Zone 2 mode.
Signals input to V-AUX and PHONO jacks cannot be sent to
Zone 2/Zone 3.
R
L
+
–
PRESENCE/ ZONE 2
Second room
This unit
Remote controlling Zone 2/Zone 3
TV VOL
PRESET PRESET
TV MUTE
TV VOL
SELECT
CHCH
+
+
–
–
TV VOL
PRESET PRESET
TV MUTE
TV VOL
SELECT
CHCH
+
+
–
–
LEARN
Note
SELECT SELECT
or
TUNERPHONO
V
-
AUX
DTV DVR/VCR2VCR 1 DVD
CBL/SAT MD/TAPE CD-R
CD
MULTI CH IN
00_HTR-5790U_EN.book Page 69 Tuesday, December 9, 2003 9:16 AM