Filter
Top Products
63
REMOTE CONTROL FEATURES
ADVANCED
OPERATION
You can clear all changes made in each function set, such
as learned functions, renamed source names and setup
manufacturer codes.
1 Press CLEAR by using a ballpoint pen or
similar object.
y
Complete each of the following steps in 30 seconds. Other
wise, the learning mode will be automatically canceled. In
this case, press CLEAR again.
2 Press u / d to select the clear mode.
L:DVD
(L: name of a component)
Clears all learned functions in the respective
component control area. Press an input selector
button to select the component.
L:AMP Clears all learned functions for this unit’s control
area.
L:ALL Clears all learned functions.
RNAME Clears all renamed source names.
FCTRY Clears all remote functions and returns the remote
to the factory settings.
3 Press and hold CLEAR again for about 3
seconds.
“C:OK” appears in the display window.
“C:NG” appears in the display window if the operation is
unsuccessful. In this case, start over from step 2.
4 Press CLEAR to exit from the clearing mode.
Once you have cleared a learned function for a
button, the button reverts to the factory setting.
“ERROR” appears in the display window under the following
circumstances:
– When a button other than the cursor is pressed.
–When more than one button is pressed at once.
■ Clearing a learned function
You can clear the function learned in a certain
programmed button in each area.
1 Press an input selector button to select the
source component containing the function
you want to clear.
The selected component name appears in the display
window.
2 Press LEARN using a ballpoint pen or similar
object.
“LEARN” and the selected component name appear
alternately in the display window.
y
Complete each of the following steps in 30 seconds.
Otherwise the learning mode will be automatically canceled.
In this case, press LEARN again.
3 Press and hold CLEAR using a ballpoint pen
or similar object, then press the button you
want to clear for about 3 seconds.
“C:OK” appears in the display window.
When you clear a learned function, the button reverts
to the factory setting (or to the manufacturer setting if
you have set manufacturer codes).
4 Repeat step 3 to clear other learned
functions.
5 Press LEARN again to exit.
Clearing function sets
Note
Note
CLEAR
CLEAR
CLEAR
Clearing individual functions
TUNERPHONO
V
-
AUX
DTV DVR/VCR2VCR 1 DVD
CBL/SAT MD/TAPE CD-R
CD
MULTI CH IN
LEARN
PHONO
POWER SLEEP
CLEAR
LEARN
STANDBY
TRANSMIT
RE–NAME
INPUT MODE
SYSTEM
V
-
AUX
DTV DVR/VCR2VCR 1 DVD
CBL/SAT MD/TAPE CD-R
TUNER
MULTI CH IN
CD
00_HTR-5790U_EN.book Page 63 Tuesday, December 9, 2003 9:16 AM