Yamaha EMX100RDS CD Player User Manual


 
E-40
CD CHANGER RECEIVER EMX
100RDS
PHONES
DISC
123
PROGRAM
MUSIC
USER
MEMORY
INPUT SELECTOR
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
VOLUME
RANDOM
DISPLAY
MIC
MIN MAX
MIC MIXING
REPEAT TIME MEMORY AUTO/MAN'L
HOUR
PRESET/TUNING/BAND
A/B/C/D/E
MIN TIME ADJ TIMER
OPEN/
CLOSE
DISC
CHANGE
STANDBY/ON
MODE PTY SEEK STARTFREQ PS/PTY/RT/CT
PTY SELECT PTY SELECT
ON TIME/time setting mode
[“ON TIME” appears on the display, and soon it is
changed to a time setting mode.]
Set to the time when you want to begin the timer play
by using the HOUR button and the MIN button.
OFF TIME/time setting mode
[“OFF TIME” appears on the display, and soon it is
changed to a time setting mode.]
If necessary, set to the time when you want to finish
the timer play (to turn this unit into the standby mode)
by using the HOUR button and the MIN button. Even
if you do not set the time, it has already been set so
that the timer play finishes after 1 hour.
Note
The TIMER button functions also in the time (ON TIME or
OFF TIME) setting mode. (However, it also turns this unit
into the standby mode.)
3 Press the TIMER button to complete the timer play
setting. (This unit turns into the standby mode.) If you will
still use this unit, press the STANDBY/ON switch to turn
on this unit.
Note
If you continue using this unit after a timer play setting is
made, the source set for the timer play will begin playing
when the time comes in place of the source played at that
time.
To cancel the timer play setting
After the timer play is finished (while the current time is
displayed), press the TIMER button so that “TIMER” goes out
from the display.
If it is not canceled, this unit will turn on at the same time
every day, so it can be used as an alarm.
* Unless the AC supply lead is unplugged or there is a
power failure for more than 5 minutes, the time set on the
timer will be retained until it is reset.
How to make time setting in the ON TIME or OFF
TIME mode
For the hour:
Press the HOUR button to change the hour to a higher value.
Press and hold to change continuously.
For the minute:
Use the MIN button and operate it in the same way as you
did to change the hour.
Note
You can also change the hour (or the minute) to a lower
value by pressing the HOUR button (or the MIN button) with
the TIME ADJ button pressed and held.
HOW TO USE THE BUILT-IN TIMER
1
1
2
2
3
3
4
4
5
5
TIME
A
DISC SKIP
PROG
B C D
+I0
E
OPEN
/
CLOSERANDOM
REPEATMODE
6
6
7
7
8
8
9 0
CD
PRESET
TUNER
STOP
INPUT
PLAY
/
PAUSE
LEVEL
MUSIC
TEST FLAT
CENTER
/
REAR
/
DELAY
PROGRAM
USER
STANDBY/ON
DISPLAY
SLEEP
VOLUME
DISPLAY
STANDBY/ON
STANDBY/ON
DISPLAY
TIMER
HOUR MIN