Filter
Top Products
E-95
SOUND FIELD
PROGRAMS
English
SOUND FIELD PROGRAM PARAMETER EDITING
You can enjoy good quality sound with the preset parameters. Although you do not have to change the initial settings, you can change some
of the parameters to better suit the input source or your listening room.
Changing parameter settings
PUSH
TV VOL CH
VOLUME
DISC
PRESET
A/B/C/D/E
TV MUTE
TV INPUT
MUTE
EFFECT
STEREO
ON SCREEN
SLEEP
LEVEL
TEST
SET MENU
PARAMETER
5
3
6
2
1
1
Turn on the video monitor.
2
2
Press ON SCREEN repeatedly to select the full
display mode.
3
3
Set PARAMETER/SET MENU to PARAMETER.
4
4
Select a DSP program you want to adjust.
5
5
Press / to select the parameter.
ON SCREEN
SET MENU
PARAMETER
≥ 70mm Spectacle
EFCT TRIM…………0dB
P.INIT.DLY……13ms
P.ROOM SIZE……1.0
S.DELAY……………23ms
S.ROOM SIZE……1.0
P10 MOVIE THEATER 1
6
6
Press +/– to change the parameter value.
When you set the parameter to a value other than the factory-
set value, an asterisk mark (*) appears by the parameter name
on the video monitor.
7
7
Repeat steps 4 to 6 above as necessary to change
other program parameters.
Cautions
• The available parameters may be displayed on more than one
OSD page for some of the programs. To scroll through pages,
press
/ .
• You cannot change parameter values when “16 MEMORY
GUARD” on the SET MENU is set to “ON”. If you want to
change the parameter values, set “16 MEMORY GUARD” to
“OFF” (see page 62).
■ To reset some of the parameters to the
factory-set values
Select the parameter you want to reset. Then press and hold +/–
until the value temporarily stops at the factory-set value. The
asterisk mark (*) by the parameter name disappears on the video
monitor.
■ To reset all of the parameters to the factory-
set values
Use “10 PARAMETER INI” on the SET MENU to reset all of the
parameter values of all DSP programs within the selected group to
the factory-set values (see page 59). This operation resets all of the
parameter values of all DSP programs within that group to the
factory-set values.