Filter
Top Products
E-76
REMOTE CONTROL FEATURES
■ Operating the macro
1
1
Set MACRO ON/OFF to ON.
2
2
Press a macro button.
Cautions
• When you have finished using the Macro feature, set MACRO
ON/OFF to OFF.
• While this unit is carrying out a macro program, this unit does not
receive any other button’s function until the macro operation has
been completed (the TRANSMIT indicator stops flashing).
• Continue to aim the remote control at the component the macro is
operating until the macro operation has been completed.
TRANSMIT RE–NAME
CLEAR LEARN MACRO OFF ON
MACRO
SYSTEM
POWER
STANDBY
V–AUX TUNER PHONO
CABLE SAT MD/TAPE CD–R CD
D–TV/LD VCR 1 VCR 2 VCR3/DVR DVD
6CH INPUT
TTE
1
2
OFF ON
MACRO
SYSTEM
POWER
STANDBY
V–AUX TUNER PHONO
CABLE SAT MD/TAPE CD–R CD
D–TV/LD VCR 1 VCR 2 VCR3/DVR DVD
■ Programming a macro
You can program your own macros and use the Macro feature to
transmit many remote control commands by pressing a single
button.
Cautions
• The factory-set macro is not cleared when a new macro is
programmed for a button. The factory-set macro can be used again
when the programmed macro is cleared.
• It is not possible to add a new signal (macro step) to the factory-
set macro. Programming a macro changes all macro contents.
• A macro programming is used to transmit learning or setup (or
YAMAHA preset) button signals of this remote control to a macro
button. If necessary, set up the manufacturer code or program a
function with the remote control for your component.
• This remote control handles button signals that operate continu-
ously, such as volume control, as short time interval codes. Macro
programming that include these types of macro steps are therefore
not recommended.
1
1
Press MACRO by using a ballpoint pen or similar
object.
“MCR ?” appears in the display window.
Caution
• If you do not press any button within 30 seconds during steps
2 and 3, the macro programming process is canceled. If this
happens, start over from step 1.
2
2
Press a macro button for which you want to program
the macro operation.
The button you chose for programming the macro operation
and the selected component name appear alternately in the
display window.
Example: Programming a macro for DVD
“M:DVD” and “DVD” appear alternately.
TRANSMIT RE–NAME
CLEAR LEARN MACRO OFF ON
MACRO
SYSTEM
POWER
STANDBY
V–AUX TUNER PHONO
CABLE SAT MD/TAPE CD–R CD
D–TV/LD VCR 1 VCR 2 VCR3/DVR DVD
6CH INPUT
TTE
1, 4
2
MACRO
MCR ?
SYSTEM
POWER
STANDBY
V–AUX TUNER PHONO
CABLE SAT MD/TAPE CD–R CD
D–TV/LD VCR 1 VCR 2 VCR3/DVR DVD
M:DVD
DVD