Filter
Top Products
4 En
Follow the procedure below to connect the speakers and FM/AM antennas to this unit. For information on your speakers,
refer to the owner’s manual supplied for the speakers.
If a subwoofer is connected, low-frequency audio signals are output through SUBWOOFER OUT.
Do not connect the power cable of this unit until all cable connections are completed.
• If you connect a subwoofer, use a subwoofer that has a built-in amplifier.
• Be sure to connect the left channel (L), right channel (R), “+”(red) “–”(black) properly. If the connections are faulty, no sound will be
heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lacks bass.
• Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could damage this unit and/
or the speakers.
• Use speakers having more than 6 Ω impedance.
• There is a chance that placing speakers too close to a CRT-based (Braun tube) TV set might impair picture color. Should this happen,
move the speakers away from the TV set.
CONNECTION
Connecting speakers/antennas/subwoofer
CAUTION
Notes
FM antenna
• The antenna should be stretched out.
• If you use an outdoor antenna instead of the
supplied FM antenna, reception will be better.
• If radio reception is poor, change the height,
direction, or placement of the antenna.
• If you use an FM antenna that is not supplied
with the unit, make sure that the base of the
antenna is not threaded.
Notes
Subwoofer cable
(sold separately)
Subwoofer (sold
separately)
Be sure to remove insulation
from the end of each speaker
cable.
• Place the antenna in a location with good signal
reception.
• Digital devices located near the antenna may
affect signal reception.
Notes
AM antenna