Filter
Top Products
TROUBLESHOOTING
14 En
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to your iPod/iPad
(see page 5).
* Messages shown above appear only when a device is connected to the iPod dock.
iPod/iPad
Note
Status message Cause Remedy Page
iPod Connecting
iPod Charging
This unit is in the middle of recognizing
the connection with your iPod.
If the message continues to appear in the front panel
display, disconnect and connect the iPod again.
5
Unknown iPod
There is a problem with the signal path
from your iPod to this unit.
Connect the iPod again.
5
The iPod being used is not supported by
this unit.
Only iPod classic, iPod nano (2nd generation and
later), iPod touch and iPhone are supported.
—
iPod
This unit has recognized your iPod;
however, it cannot obtain information
such as elapsed time.
iPod Unplugged
Your iPod was removed. Connect the iPod again.
5
Over Current
The iPod being used is not supported by
this unit.
Disconnect the iPod and then turn the unit off and on
again. Then connect supported iPod again.
5
The iPod is connected at an angle.
Problem Cause Remedy Page
No sound. The power of the unit is off. Connect the power cable correctly.
—
The iPod/iPad software version has not
been updated.
Download the latest iTunes software to update the
iPod/iPad software version to the latest.
—
The iPod/iPad is in the process of
connecting with the unit.
Please wait for a while.
—
The iPod/iPad is not connected correctly. Remove the iPod/iPad from the unit, then connect it
again.
5
The iPod/iPad
sounds, but you
cannot operate it with
the unit or the remote
control.
The iPod/iPad is not connected correctly. Remove the iPod/iPad from the unit, then connect it
again.
5
You cannot operate
from the iPod/iPad.
The iPod/iPad is not connected correctly. Remove the iPod/iPad from the unit, then connect it
again.
5
The playback
information is not
displayed on the
front panel display.
The iPod/iPad you set is not compatible
with the playback information display.
Only iPod classic, iPod nano (2nd generation and
later), iPod touch, iPhone and iPad are supported.
5
The iPod/iPad does
not charge up.
The iPod/iPad is not connected correctly. Remove the iPod/iPad from the unit, then connect it
again.
5
Suddenly the music
being played back is
canceled and another
track starts playing
without performing
any operation.
The iPod’s Shake to Shuffle function is
turned on.
Turn off the Shake to Shuffle function in the iPod’s
settings.
—