Filter
Top Products
ACD1 Reference Manual
7
Panel operations
By pressing buttons on the panel you can monitor or control various parameters of the ACD1 itself or of the con-
nected amplifiers.
The following parameters can be monitored/controlled.
Category Sub category Operation performed
1. Scene
(page 10)
Recall Recalls a scene on the specified amplifier.
Store Saves a scene for the specified amplifier.
2. Amp Control
(page 11)
On/Standby Switches the power of the specified amplifier between On and Standby.
Mute Mutes or unmutes the channel of the specified amplifier.
Attenuation Adjusts the channel attenuator value of the specified amplifier. (PC-N/Tn series
only)
3. Output Monitor
(page 12)
Displays the output level of the specified amplifier.
4. Device Setup
(page 12)
Device ID Specifies the ACD1’s Device ID address.
Device Label Displays the name of the ACD1 assigned by Amp Editor.
Identify Blinks the “Identify” icon of the corresponding ACD1 in Amp Editor.
5. Utility
(page 13)
Battery Displays the state of the ACD1’s internal backup battery.
Firmware Ver. Displays the ACD1’s firmware version.
LCD Backlight Selects whether the ACD1’s LCD backlight will be always lit (ON) or lit only during
operation (Auto OFF).
Panel Operation Restricts panel operations of the ACD1.
Scene Recall Specifies whether scene recall from the ACD1’s panel is enabled (Enable) or dis-
abled (Disable).
EMG Scene Setup Specifies the scene number that will be recalled when the EMG (Emergency) sig-
nal is received from an external controller. If this is OFF, a scene will not be
recalled even if an EMG signal is received.
Last Mem. Resume Specifies whether the ACD1 will start up with the settings that were in effect when
the power was last turned off (ON) or whether it will start up by recalling the amp’s
scene number that was in effect when the power was last turned off (OFF).
Clock Sets the date and time of the ACD1’s internal clock.
GPI Calibration Calibrates the [GPI IN] connector input voltage.
6. Network Setup
(page 16)
IP Address Mode Selects whether the ACD1’s IP address will be set automatically from Amp Editor
(Auto) or set manually (Manual).
IP Address Specifies the ACD1’s IP address.
MAC Address Displays the ACD1’s MAC address.
IP Ctrl Port # Specifies the port number used when controlling the ACD1 via Ethernet from an
external controller such as AMX/Crestron.