Filter
Top Products
ACD1 Reference Manual
2
Contents
Introduction............................................. 3
About the documentation .................................3
Supported amplifiers.........................................3
Setup...................................................................3
Terms ..................................................................4
Controls and Connectors ...................... 5
Front Panel .........................................................5
Rear Panel ..........................................................6
Panel operations .................................... 7
Basic operation..................................................8
Scene (“1. Scene”)...........................................10
Recalling a scene (“1. Scene” ➝ “Recall”)............10
Storing a scene (“1. Scene” ➝ “Store”).................10
Controlling an amplifier (“2. Amp Control”)..11
Power on/standby
(“2. Amp Control” ➝ “Standby”).......................11
Mute (“2. Amp Control” ➝ “Mute”).........................11
Attenuator value adjustment
(“2. Amp Control” ➝ “Attenuation”)..................11
Amplifier output monitor
(“3. Output Monitor”).......................................12
Amplifier output (“3. Output Monitor”) ...................12
Device setup (“4. Device Setup”) ...................12
Device ID setting
(“4. Device Setup” ➝ “Device ID”) ...................12
View ACD1 name
(“4. Device Setup” ➝ “Device Label”)..............12
Identify (“4. Device Setup” ➝ “Identify”)................13
Utility (“5. Utility”)............................................13
Backup battery check (“5. Utility” ➝ “Battery”)......13
Version indication (“5. Utility” ➝ “Firmware Ver.”)..13
LCD backlight (“5. Utility” ➝ “LCD Backlight”).......14
Restricting panel operations
(“5. Utility” ➝ “Panel Operation”) .....................14
Enabling scene recall operations from the panel
(“5. Utility” ➝ “Scene Recall”)..........................14
Enabling scene recall operations via
EMG commands
(“5. Utility” ➝ “EMG Scene Setup”) .................15
LAST MEMORY RESUME setting
(“5. Utility” ➝ “Last Mem. Resume”) ................15
Clock setting (“5. Utility” ➝ “Clock”).......................15
GPI IN calibration
(“5. Utility” ➝ “GPI Calibration”).......................16
Network settings (“6. Network Setup”)..........16
IP Address Mode setting
(“6. Network Setup” ➝ “IP Address Mode”).....16
IP Address setting
(“6. Network Setup” ➝ “IP Address”)...............16
Checking the MAC address
(“6. Network Setup” ➝ “MAC Address”) ..........16
Port settings for an external controller
(“6. Network Setup” ➝ “IP Ctrl Port #”)............17
Initializing the ACD1 ........................................17
Connector wiring .................................. 18
Euroblock plug connection.............................18
GPI connector ..................................................19
FAULT OUTPUT connector.............................20
Appendix ...............................................21
Display messages............................................21
List of supported characters ..........................21
Troubleshooting...............................................22
Specifications...................................................22
Control I/O ........................................................23
Pin Assignment................................................23
MONITOR/REMOTE.............................................23
DATA PORT ..........................................................23
Dimensions.......................................................24