Filter
Top Products
7
Installation and Set-up
Unpacking
Carefully unpack your Wadia 931 Digital Controller and the two Wadia 921 Mono Decoding Computers. Inspect
the outside of the chassis for shipping damage. If you find any, report it to your dealer immediately.
Do not plug in the Wadia 931 Digital Controller if you see any signs of shipping damage.
Please save all packing materials so the unit can be easily and safely shipped if the need arises.
Placement
Wadia 931 Digital Controller
Much like an analog preamplifier, the Wadia 931 Digital Controller should be centrally located near your
source components. Because the Wadia 931 Digital Controller is connected to the Wadia 921 Mono Decoding
Computers via glass fiber cabling, there is no advantage to placing it nearby these units.
Wadia 921 Mono Decoding Computers
The Wadia 921 Mono Decoding Computers should be placed as near to the amplifier or amplifiers as possible.
This will allow you to use shorter interconnecting cables thereby maximizing system performance.
AC Power
Please check to see what AC line voltage your unit is set for. Connecting to any voltage other than that specified
on the back panel will result in damage that is not covered by the warranty.
We recommend that you do not turn on the AC power until you have completed all connections between the
components of your system.
Installing the Tip-Toes
Screw one of the tip-toes under each of the three recesses in the bottom of the Wadia 931 Digital Controller and
both of the Wadia 921 Mono Decoding Computers. If the surface on which you intend to place the Wadia 931
Digital Controller is susceptible to damage, make sure to place one of the steel coasters under each tip-toe.