Filter
Top Products
22
seri es 9 Decoding Computer System
Configuration
Entering Configuration Mode
To enter configuration modes, the user uses the enter key on the remote or front panel to scroll through the
main screens to reach the “Enter Configuration Mode” screen.
Using the Next Input or Previous Input front panel controls, the user selects “Y”, and presses enter.
Navigating in Configuration Mode
Once in configuration mode, the front panel controls change function:
The left, right, up and down keys are used to position the cursor, enter is used to make your selection and move
to the next screen.
Menu Screen Map
On the following page is a map for navigating while in Configuration Mode. To move to the next screen, make
your selection using the Right and Left keys, then press enter to move to the next screen.
Configuration Functions
There are three categories of configuration parameters on the Wadia 931 Digital Controller:
• Configure Inputs
• Configure Outputs
• Reset to factory default configuration