Filter
Top Products
user manual
TCS Compact series
TCS-C50T manual
page 14
Servicing Information
If any of the drive units in your TCS series product should cease functioning and need a
replacement re-cone or diaphragm, you are advised to remove the faulty unit from the
installation, remove the faulty drive unit(s) and send it to a professional service centre
authorised to repair Turbosound loudspeakers.
Removal of the low frequency woofer
The perforated steel loudspeaker grille is a push fit in the loudspeaker frame. To remove
the grille, using a pointed object such as a pin inserted through the mesh of the grille,
gently lever the grille away from the frame. Set the grille aside for later re-assembly.
Undo the screws holding the back can in place and place to one side. The low frequency
drive unit will be accessible once the line transformer has been removed from the back of
the loudspeaker frame. Make a note of the driver terminal polarity for later reconnection.
Disconnect the cables from the drive unit and completely remove the driver from the
speaker being careful not to damage the cone or suspension. Do not place the driver
near to any equipment or media that may be adversely affected by strong magnetism,
e.g. CRT monitors or tape of any kind.
Removal of the high frequency tweeter
Disconnect the cables from the tweeter, making a note of the driver polarity for later
reconnection. Undo the screws holding the tweeter in place and carefully lift it out and
away from the speaker. Do not place the driver near to any equipment or media that may
be adversely affected by strong magnetism, e.g. CRT monitors or magnetic tape of any
kind.
To reinstate the driver(s) simply reverse the above procedure, making sure you observe
the correct polarity when reconnecting the cables back into the terminals of the drive
units.